The checklist below may help you troubleshoot in the unlikely event that a problem occurs while using the product:
No response from unit. No power to unit. Check that power is turned on.
Check cables and connections.
Fuse blown or internal fault.
or Beamz authorized service partner. Do not
remove base or yoke covers. Do not attempt
to replace a fuse or carry out any repairs or
service that are not described in this User
Manual unless you have both authorization
from Beamz support or Beamz authorized
service partner.
Light output cuts out intermittently. Unit too hot. Allow unit to cool. Reduce ambient
temperature. Ensure free airflow around unit.
Clean unit if necessary.
LEDs damaged. Disconnect unit and contact Beamz support
or Beamz authorized service partner.
The power supply settings do not
match local AC voltage and
frequency.
Disconnect unit. Check settings and
correct if necessary.
To Next Page
Loading...
