Beamz illusion 2 - Menu Function Settings (Part 2)

6
6）Sound sensitivity Setting (before this setting, please Press MENU into < Lost> to select <Sound> and save, fixture
should be in Sound Mode first)
1. Press MENU to enter EDIT interface
2. Press UP/DOWN to choose, then press ENTER to enter (Sound send)
3. Press <Up/Down>, <Enter> to adjust the sound sensitivity from 000-099.
4. Press <Enter> to confirm, or press "MENU" to exit.
7) Pan angle setting
1. Press<MENU> to enter EDIT interface.
2. Press UP/DOWN to choose, then press ENTER to enter (Panmotor Angl).
3. Press<Up/Down> to choose ‘630’ or ‘540’.
4. Press <Enter> to confirm, or press "MENU" to exit.
8) Pan reverse setting
1. Press<MENU> to enter EDIT interface.
2. Press UP/DOWN to choose, then press ENTER to enter (Pan invert).
3. Press<Up/Down> to choose ‘YES’ or ‘NO’
4. Press <Enter> to confirm, or press "MENU" to exit.
9) Tilt reverse setting
1. Press<MENU> to enter EDIT interface.
2. Press UP/DOWN to choose, then press ENTER to enter (Tiilt invert).
3. Press<Up/Down> to choose ‘YES’ or ‘NO’.
4. Press <Enter> to confirm, or press "MENU" to exit.
10) Pan fine setting
1. Press<MENU> to enter EDIT interface.
2. Press UP/DOWN to choose, then press ENTER to enter (Pan fine)
3. Press<Up/Down> to choose ‘000-255”’ Press <Enter> to confirm,or press "MENU" to exit.
11) TILT fine setting
1. Press<MENU> to enter EDIT interface.
2. Press UP/DOWN to choose, then press ENTER to enter (Tilt fine)
3. Press<Up/Down> to choose ‘000-255”’
4. Press <Enter> to confirm, or press "MENU" to exit.
12）LED back light setting
1. Press MENU to enter EDIT interface.
2. Press UP/DOWN to choose, then press ENTER to enter (Display Bklight).
3. Press<Up/Down> to choose ‘ON’ or ‘OFF’.
4. Press <Enter> to confirm, or press "MENU" to exit.
13) Working time
1. Press < ENTER> to enter EDIT interface.
2. Press < UP/DOWN>, then press < ENTER> (TotalRun Time) to check the light’s working time.
3. Press <Enter> to confirm, or press "MENU" to exit.
14）Software Version
1. Press < ENTER> to enter EDIT interface.
2. Press < UP/DOWN>, then press < ENTER> (Software Version) to check the light’s version information.
3. Press <Enter> to confirm, or press "MENU" to exit.
15）Whole fixture reset
1. Press< MENU> to enter EDIT interface.
2. Press UP/DOWN to choose, then press ENTER to enter (ALL Reset).
3. After reset, it will go back to the upper interface
16）Factory default settings
1. Press MENU to enter EDIT interface.
2. Press UP/DOWN to choose, then press ENTER to enter (ALL Default).
3. Press<Enter> to confirm, or press "MENU" to exit.