EasyManua.ls Logo

BEARMACH BA 3228 - Simple Fault Analysis; Refrigerator Not Working; Abnormal Noise; Condensation Issues

BEARMACH BA 3228
7 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
There are 3 minutes time delay to protect the compressor,which means after
the car fridge turned on,the compressor will not work at once,
it will start to
work after 3 minutes.And at this time,the cabinet temperature in the fridge
> the setting temperature(+3C),and
turned on.When the cabinet temperature
in the fridge = the setting temperature,compressor stop working.
To protect the compressor,it will restart to work again after at least 3 minutes.
Power memory function:After restart,the temperature set will be as same same
the one you set before power off.
4.Simple Fault Analysis
The refrigerator does not work
Check if the power supply is connected correctly (whether the plug is loose,
whether the positive and negative poles are connected incorrectly)
Check if the ventilation and ventilation conditions are normal.
Check if the fuse is blown
Check if the power switch on the control panel is turned on.
Abnormal noise in the refrigerator
The car refrigerator is not placed smoothly
Hit the wall or other items
internal parts loose or fall off
Condensation on the surface of the refrigerator
When the ambient air humidity is >75%, the surface of thecabinet may be
slightly condensed. The higher the humidity, the greater the probability of
occurrence, which is normal.
Refrigerator cooling is not good
The food storage is too large, placed crowded, cold air flow is
not smooth
The door is not closed
The door cover sealing strip is damaged or deformed, and the sealing property
is deteriorated;
Poor ventilation in the radiator of the car
Put too much hot food
Improper working mode of the refrigeratorrefrigerator
Sunlight or near heat source
improper temperature setting