EasyManua.ls Logo

BEARMACH BA 3228 - Error Code Displays; Cleaning And Maintenance; Cleaning Method; Plastic Parts Maintenance

BEARMACH BA 3228
7 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Similar to the sound of running water in the refrigerator
This is the flow sound of the refrigerant, which is normal.
There will be a loud sound when the compressor starts up
When the compressor starts, the sound will be slightly larger, and the
sound will decrease after the speed is stable, which is normal.
LED display ER0
Temperature sensor short circuit
LED display ER1
Input under-voltage protection, not enough voltage for module
LED display ER2
DC fan over-current protection
LED display ER3
Compressor abnormal start protection
LED display ER4
Rotational speed of compressor is abnormal
The temperature of module is abnormal
LED display ER5
LED display ER9
Temperature sensor open circuit
5.Cleaning And Maintenance
Cleaning method:
Clean the appliance inside and out with a clean damp cloth every two
weeks.
If it is dirty, wipe it with a
neutral detergent and then wipe it drywith a damp
cloth. If there is too much water, you can use the drainagepipe at the bottom
of the tank to drain
Maintenance of plastic parts:
To properly protect the seals, clean the plastic parts frequently and try to
avoid
heavy impact during use. If oil(Animal or vegetable oil)is attached
plastic parts
for a long time, the plastic will easily deteriorate and crack,and smells bad.