BEARWARE 302653 - Timer Program Configuration; Setting Timer Programs

34 English
8. Seng the mer programs
Press the PROG buon briey. You can rst set the me at which the connected
device has to be switched on (ON).
Press the WEEK buon unl the desired days of the week on which the mer
programme has to be executed are shown on the display. Now set the desired
me using the "HOUR" and "MIN" buons.
Then press the PROG buon again. You can then set the me at which the
connected device has to be switched o (OFF). Congure the me and days of the
week using the WEEK, HOUR, and MIN buons as described in the previous step.
Note: Please remember that the days of the week for switching on and switching
o have to be congured separately. The selected combinaon is not automacal-
ly adopted for the enre mer programme.
Press the PROG buon briey. You can then congure the second mer program.
A total of 8 mer programs are available, which you can congure in this way.
Once all the programs have been customised as needed, please press the CLOCK
buon. The display again shows the current me and the day of the week. The
mer is now ready for use.
Note: Please ensure that the mes of the individual mer programmes do not over-
lap in order to avoid unintenonal switching on or o.
To disable a mer programme again or to enable a disabled program, press the
PROG buon unl the desired program is shown in the display. You can now
enable or disable the mer program using the R buon.