BEARWARE 303457 - Basic Settings Configuration

24 English
Once the aempt to receive a signal fails, the weather staon stops scanning aer
about 5 minutes. The DCF symbol disappears from the display.
Cauon! Remember that some devices may be sources of interference for receiving
the signal, such as televisions, computers, etc. You may have problems in receiving
the signal in closed areas such as an airport, factories, cellars etc.
7. Basic sengs
Note: When the backlight is switched o ("backlight" switch in O posion),
the backlight can be turned on for approximately 5 seconds by pressing the
large "SNOOZE / LIGHT" buon at the top of the housing.
Press and hold the "TIME SET" buon for about 3 seconds to modify the basic
sengs. With the "CHANNEL/+" and "MEM /
_
" buons you can change the
values accordingly.
By briey pressing the "TIME SET" buon, you can conrm the entry and proceed
to the next opon. In this way, you can change and customise the following
sengs in the sequence menoned below:
• 12/24 hour format
• Hour
• Minute
• Second
• Year
• Month / Day format
• Month
• Day
• Time zone - Note: If you set the me zone, for example, to + 01 and the weath-
er staon is actuated using the DCF-signal, then the clock displays one hour
later than the DCF-signal.
• Language seng - To set the day on the display. The following codes can be
congured and selected using the "UP" and "DOWN" buons: EN (English), RU
(Russian), NL (Dutch), IT (Italian), ES (Spanish), DE (German), FR (French)
• RC - Enable or disable the DCF signal funcon.
• DST - Enable or disable automac switching to daylight saving me.