BEARWARE 303457 - Display Indicators and Sensor Signal; Low Battery and Frost Indicators; Outdoor Sensor Signal Handling

27English
Low baery:
If the baery symbol appears, then the inserted baeries are discharged and
should be replaced with new baeries as soon as possible. This applies to the
outdoor sensor as well as to the base staon. If the empty baery icon appears
next to the inside temperature, the baery of the weather staon is empty.
Outdoor temperature display:
The outdoor temperature is measured by the outdoor sensor and shown to an
accuracy of one tenth of a degree. The congured temperature unit is shown to
the right of the measured value. The temperature unit can be changed between
°C and °F. To do this, slide the °C / °F switch on the back of the weather staon to
the desired posion.
Channel display
The weather staon receives the signal of the outdoor sensor automacally. You
can switch between the dierent channels using the "CHANNEL/+" buon. Select
the same channel, which you select for the outdoor sensor. The channels of the
outdoor sensor can be selected on the device directly using a toggle switch. The
Auto Cycle mode can be turned on by pressing and holding the "CHANNEL / +"
buon for about 2 seconds.
Receiving the outdoor sensor signal
The outdoor sensor sends a signal twice a minute, which is automacally received
by the base staon. You can also manually enable the signal recepon. Press
the "Sensor" buon on the back of the device unl the scan icon (" ") starts
ashing. Once the signal has been successfully received, the animaon of the
symbol disappears and the received temperature is shown on the display of the
weather staon.
Frost icon
With the temperature alarm, the base staon shows a " " icon in the display
when the temperature falls below the 3°C mark in the outdoor display.