BEARWARE 304273 - Page 24

24 English
8. Basic sengs
Note: Pressing the "SNOOZE/LIGHT" buon at the top of the housing
switches the backlight on. Please note that the base staon does not
respond to 2 buons at the same me. Therefore, it is advisable to press
only one buon.
When supplying power from the mains, pressing the "SNOOZE/LIGHT"
buon repeatedly changes the brightness levels of the backlight in steps.
Press and hold the "MODE" buon in the default screen for about 5 seconds to
congure the basic sengs. With the "UP" and "DOWN" buons, you can change
the values accordingly.
By briey pressing the "MODE" buon in the me sengs, you can conrm the
entry and proceed to the next opon. In this way, you can change and customise
the sengs in the following sequence:
• Year
• Date format
• Month
• Day
• Hour
• Minute
• 12/24 hour format
• Time zone - Note: If you set the me zone, for example, to + 01
and the weather staon is actuated using the DCF-signal, then the
clock displays one hour later than the DCF-signal. Enable the me
zone by briey pressing the "DOWN" buon in the default screen.
"ZONE" is displayed next to the me.
• Language seng - To set the day on the display. The follow-
ing codes can be congured and selected using the "UP" and
"DOWN" buons: GER (German), DAN (Danish), SPA (Spanish),
NLD (Dutch), FRA (French), ITA (Italian), ENG (English)
• Current weather - Displayed as a pictogram
• Unit of air pressure - Select between "inHg" and "hpa"
• Air pressure reading - You can obtain the current air pressure for
your locaon from the weather informaon on the Internet.