BEARWARE 304950 - Page 18

18 English
6. Seng the current me
1. Press and hold the "C+" buon. Press the "W+" buon repeatedly at the
same me. The current day in the mer display changes every me the
buon is pressed. Keep pressing the "W+" buon unl the current day is
displayed.
2. Connue by pressing the buon "H+" or "M+" unl the current hour or min-
ute is displayed. The "W+", "H+" or "M+" buons can be pressed and held
during seng for incremenng quickly.
3. Release both the buons to stop the seng.
4. To reset any incorrect entry, repeat the above steps.
7. Seng the mer programs
Note: Check your programs to ensure that the sengs do not overlap, especially
when using the block opon. If the program sengs overlap, then the Timer ON or
OFF is executed based on the program me and not the program number.
OFF Program always has priority over ON program.
1. Press the buon once and release. LCD shows 1
ON
--:--. The rst ON
seng can now be setup.
2. Press the "W+" buon to set the day or block of days. Set the me by
pressing the "H+" or "M+" buon.
3. Press the buon once again to complete the rst ON seng and to
adjust the rst OFF seng. The LCD display shows 1
OFF
--:--. Repeat step 2 to
complete the rst OFF seng.
4. Press the buon once again to complete the rst OFF seng and to
adjust the second ON seng.