Beats SOLO3 - Voice Commands and Battery Status; Maintenance and Updates; Resetting Headphones; Software Updates

4/5/2017 SetupanduseyourSolo3WirelessHeadphones
https://www.beatsbydre.com/support/howto/setupandusesolo3wireless 3/7
To activate Siri on your iOS device or the voice-command feature on another device, use the b
button on the left earcup, or the center button on the RemoteTalk cable. Just press and hold until
you hear a chime, then say what you need.
To check the Fuel Gauge, which shows battery level and charging status, press and release the
power button.

Reset
1. Hold down these two buttons for 10 seconds:
2. When the Fuel Gauge flashes, release the buttons. Your headphones are now reset and ready
to be set up with your devices again.

Update
Your headphones are automatically kept up to date when they're set up with an iPhone using iOS
10.
Was this helpful?
Press once to answer a second incoming call and put the first call on hold. When two calls are
active, this switches between calls.
Press and hold for 1 second to reject an incoming call.
Press twice to stop listening through your headphones and send the call to the phone.
 Power button
 Volume down (-) button