Operation
- Before starting the engine, be sure the area around the prop is clear and the clutch is in neutral. The clutch
and engine are wired so that the engine cannot start if the clutch is engaged or in the on position.
-The momentary clutch position is useful when maneuvering to load the boat, coming up to dock, motoring
in tight quarters, etc.
- When starting out the prop should be slightly below the water and the engine should be at an idle. Do not
engage the clutch at higher rpm’s as this can damage the clutch and is not covered under warranty.
-The engine governor should be adjusted to run between 3800 and 4000 full throttle rpm under no load for
peak performance on the water.
Raise
On
Neutral
Tilt and trim switch
Electric
Clutch
Switch
To Next Page
Loading...