Wireless Headset for Chapter Flight Simulator
This 2.4G Wireless gaming headset is used to support remote orientations on the flight
simulator. The USB dongle is connected to a USB port on the chapter’s projection PC
(located on the counter to the right of the flight simulator). The headset is used to
communicate with the orientation trainer via a Zoom session on the projection PC.
In the future we may also be providing this for normal use on the Flight Simulator but for now,
it’s just for remote training and orientations.
NOTE: The user must take care when moving the position the microphone on the headset.
Do not grab the end of the boom mic to move it up or down – you may damage it. If the
boom microphone is in the folded/up position, then do the following (before putting the
headset on your head). While holding the left side earcup with one hand, use the index finger
and thumb of the other hand to grab the mounting base of the microphone (where it attaches
to the earcup) and carefully rotate the microphone boom from it’s upright position (in a
counter-clockwise direction) to about 120 degrees. In other words, turn it to the left like a
knob. Do not rotate more than 120 degrees as it has a ‘hard stop’ at that position. It should
look like the photo above after you have correctly position the microphone for use. In a
similar manner, when finished using the headset, carefully rotate the microphone boom
(clockwise) back to the vertical/closed position for storage.
To Next Page
General