To Next Page

To Previous Page

USER INSTRUCTIONS

Push the Isofix connectors directly into the anchorages until you hear an audible

sound “click”. The Isofix indicator must be green.

Grasp the seat body to check the seat if it is fastened tightly or shakes, meanwhile

observe the Isofix red/green indicator. If the seat shakes and the Isofix connectors

are pulled out, please repeat the above steps and install it again.

Press and hold the button of the Top Tether and release the Top Tether to a proper

length.

Put the Top Tether into one of the guides on the shoulder. Please hook the Top

Tether fixing hook to the one recommended in the vehicle user manual. Pull the free

end of the Top Tether to tighten until the indicator of the Top Tether turns green

completely.

Press the rotating button, adjust the seat to sideward facing position and allow

access for placing a child to the seat unit after the car seat is fitted.

Caution:

1) The seat can be 360 rotated without limiting.

2) Before every journey, make sure that the rotating part has been fully engaged. Do

not drive unless the seat is forward or rearward facing position.

Loosen the shoulder straps by pressing the harness adjusting button and pull the

harness shoulder as far forward as possible.

Open the buckle by pressing the red button, then hook the two buckle tongues at

the special buckle storage position.

Place your child in the safety car seat.

Please note a correctly headrest position that ensures optimal protection for your

child in the safety seat. The headrest must be adjusted so that the shoulder straps

are at the same level as your child’s shoulders or slightly above.

Guide the two buckle tongues together and engage them before putting them into

the buckle, this should make a clicking sound.

Tighten the harness adjusting strap and make sure the harness is reasonably tight. It

should restrain but not make the child uncomfortable.

Press the rotating button to adjust the seat direction at rearward facing position.

Caution:

1)Please ensure that the lap strap is worn low down, so that the pelvis is firmly

engaged. Pull on the strap until it lies flat and is close against your child’s body. The

straps should be correctly adjusted and ensure they are not twisted.

Bebe Stars SUPREME User Manual

Questions and Answers: