To Next Page

To Previous Page

Press the rotating button to adjust the seat direction at forward facing position.

Caution:

1)Please ensure that the lap strap is worn low down, so that the pelvis is firmly

engaged. Pull on the strap until it lies flat and is close against your child’s body. The

straps should be correctly adjusted and ensure they are not twisted.

2) Pull the strap end straight towards you, not upwards or downwards. Please pay

attention to the strap end. While traveling (especially outside the car) is should

always be attached to the cover.

2.3. FORWARD FACING: 100-150 CM

Remove the inner cushion, loosen the shoulder straps by pressing the harness

adjusting button and pull the harness shoulder as far forward as possible.

Remove the shoulder pad covers from belts.

Place the shoulder strap behind the headrest cover, open the cover of buckle

storage, disassemble the buckle properly from straps, and then put it in the buckle

storage.

METHOD 1: ISOFIX + 3-POINT VEHICLE BELT

Press the Isofix release button to slide the Isofix connectors to the end.

Caution: Please only move to the nest step when Isofix has been slid to the end with

appearing the red marks.

Push the Isofix connectors directly into the anchorages until you hear an audible

sound “click”. The Isofix indicator must be green.

Grasp the seat body to check the seat if it is fastened tightly or shakes, meanwhile

observe the Isofix red/green indicator. If the seat shakes and the Isofix connectors

are pulled out, please repeat the above steps and install it again.

Adjust the height of the headrest to suit your child’s height. Put the vehicle belt

through the belt guide. Place your child into the car seat and let the vehicle belt pass

the belt guide. Fasten the vehicle belt with an audible sound “click”.

Caution: Make sure lap strap is worn low down, so that the pelvis is firmly engaged.

Pull on the strap until it lies flat and is close against your child’s body. The straps

should be correctly adjusted and ensure they are not twisted.

METHOD 2: 3-POINT VEHICLE BELT

Put the car seat in the vehicle seat.

Adjust the height of the headrest to suit your child’s height. Put the vehicle belt

through the belt guide. Place your child into the car seat and let the vehicle belt pass

the belt guide. Fasten the vehicle belt with an audible sound “click”.

USER INSTRUCTIONS

Bebe Stars SUPREME User Manual

Questions and Answers: