Becker DTM - Page 17

Subject to correction and technical modifications 41 Copyright by Becker GmbH, D-76303 Karlsbad
,QVWDOODWLRQJXLGH
&KDQJLQJWKHFDOLEUDWLRQ!
Deleting the calibration:
If the navigation system is removed from one vehicle and installed in
another, it must be calibrated. However, to do so, the current calibration
data must be deleted.
In the Service Mode, select
! using the right rotary
control and press to confirm.
Using the right rotary control select
! and press to confirm.
The calibration is deleted and the unit returns to the Service Mode.
Calibration setting:
)
&DOLEUDWLRQVHWWLQJVVKRXOGRQO\EHPDGHZKHQWKHYDO
XHVWREHHQWHUHGDUHNQRZQ7KHXQLWFDQQRWSHUIRUP
FRUUHFW URXWH FDOFXODWLRQV LI LQFRUUHFW YDOXHV DUH HQ
WHUHG
It is possible to provide calibration settings.
In the Service Mode, select
! using the right rotary
control and press to confirm.
Using the right rotary control select
& and press to confirm.
Unit rotation can be selected in degrees by turning the right rotary
control and pressing to confirm.
 

!
!!

&
 

!
!

!!
'!"!!!
