Subject to correction and technical modifications 42 Copyright by Becker GmbH, D-76303 Karlsbad
,QVWDOODWLRQJXLGH
)
Unit rotation corresponds to horizontal rotation. A positive
value means rotation of the front of the unit towards the
driver (LHD).
The unit inclination can now be selected in degrees by turning the right
rotary control and pressing to confirm.
)
Unit inclination corresponds to vertical inclination. A posi-
tive value means upward inclination of the front of the unit.
The number of wheel impulses per wheel revolution (if known) can then
be selected by turning the right rotary control and pressing to con-
firm.
)
If the number of wheel impulses per wheel revolution is not
known,
"$ must be selected. It is then not possible
to enter tyre data.
The previously entered data is displayed once more. If the data entered
is correct, press the right rotary control .
If correction is necessary, select
& by turning the right rotary
control and press to confirm. The values can then be re-entered.
Once the previously entered data has been confirmed, the tyre data can
be entered or self-calibration can be started.
To enter the tyre data, select
"!!&#" by turning the
right rotary control and press to confirm.
"!!
$"
"$
EVENQEPT
&
D
"!!&#"
To Next Page
Loading...
Need help?
General
