Appendix
CX9000 / CX901056 Version: 2.6
Copy files to Harddisk
To make the new image work perfectly new configuration and program files are needed. They must be
copied to the internal flash. There are two ways to make the files accessible to the system. If the system
consists of interfaces CX9000-N010 or CX9000-N070 a USB-stick can hold the files. The system interface
CX9000-A001 can make the files available via a CF-card. If there are none of the suggested system
interfaces the files must be made available via a network drive (see above)
Next step is to delete the files on the internal flash. To do so just delete all files on "/Hard Disk". All files that
can not be deleted must be renamed.
Now all files from the archive can be copied to the "Hard Disk". When all files are copied reboot the system.
The renamed files can be deleted and the update is complete.
To Next Page
Loading...
Need help?
General
