USER MANUAL – MODELS 6002NA/V1/V2/ & 7002xx
QUESTIONS? EMAIL US AT INFO@BEDJET.COM OR CALL 401-404-5250
WE ARE HERE TO HELP – PLEASE CALL US FOR ADVICE!
Revision 1.6 www.bedjet.com P a g e | 27
Troubleshooting
Use this guide to address problems with your BedJet Product. If problems cannot be resolved, please
contact Customer Service at info@bedjet.com or +1.401.404.5250. Do not return any product requiring
service without first obtaining Return Authorization Number (RMA) and shipping instructions.
BedJet Audible Notifications – What does the BEEP mean?
BedJet switched on
Cooling/heating mode ON command
received from the remote control or App
Air Flow increase/decrease command
received from remote control or App
This is normal operation
Cooling/heating mode OFF command
received from the remote control or App
This is normal operation
Remote control learning/pairing function
has been successfully accomplished
This indicates successful learning/pairing
of a remote control to the BedJet
Remote control has not been learned if 3
beeps are not made
User is over-cycling the Turbo-Heat mode
by running it more than 10 minutes out of
every 30 minutes. This over-cycling is
caused by turning the Turbo-Heat back on
over and over again after shutoff, or
constantly advancing the auto-shutoff
timer.
Follow the instructions on Turbo-Heat
mode. Stop trying to over-cycle this
setting. While the BedJet machine can
handle operating in this mode
continuously, over-cycling will not be
comfortable for a person in the bed due
to the very high levels of warming.
A system monitoring error has occurred
The BedJet will be non-functional until
resolved
CHECK POWER LED FOR BLINKING LIGHT,
THE # OF BLINKS IN SEQUENCE WILL BE
AN ERROR CODE.
See diagnostic table below
Call BedJet technical support after
checking Power LED for blinking light
error code (count the blinks)
To Next Page
Loading...
