Jeep Wrangler TJ Bedrug/BedTred Interior Installation Instructions
INSTALLING FRONT FLOOR PIECES
6. Adjust the front seats to the rear most position to allow maximum clearance for installation. Place front
floor pieces into place. (Fig. 5) Tuck under console and around seat brackets as shown. (Fig. 6)
(Tip: removing bolts from rear and/or front cup holders will allow console to lift up and position liner
underneath easily – Reference picture 9)
7. Once properly aligned, pull back part to access the two pieces of hook fastener (Fig. 7). Clean surface
with alcohol then remove the film backing and roll the part back into place. Firmly press the top surface
to ensure adhesive attachment. (Fig. 8) Repeat for other front floor piece.
FIGURE 5:
FIGURE 7:
FIGURE 6:
FIGURE 8:
FIGURE 9:
FIGURE 10:
INSTALLING REAR FLOOR PIECE
8. Adjust the front seats to the fully forward and tilted up (passenger entry) position. Loosen the two screws
located in the bottom of the cup holders on the rear of the console if equipped. (Fig. 9) Next place the
rear floor piece into place. (Fig. 10)
BEDRUG, INC.
Q
635 Old Hickory Blvd, Old Hickory, TN 37138-3162
Q
800-462-8435
Q
www.bedrug.com
To Next Page
Loading...
