Bedslide SIDE KIX User Manual

GET TO IT.
Supplied Hardware: (8) TRAX slot mounts,
(8) 1/4-20 X 1 1/4” phillips combo head,
(8) 1/4-20 serrated flange nuts, (4) Side towers,
(4) 1/4-20 x 3/4 button head bolts, (4) D-ring tie downs,
(1) 58” Guardrail
Tools Needed: Phillips screwdriver, 1/8” allen wrench,
7/16 wrench
SIDE KIX
STEP 1.
ATTACH TOWERS TO SIDE KIX
Align pre-drilled holes inside the bins with the mounting holes on each TOWER. Flat side of the
TOWERS must face out. Secure the TOWERS to each SIDE KIX using the supplied 1/4-20 x 1 1/4
Phillips combo head bolts and 1/4-20 serrated flange nuts as illustrated below.
DO NOT OVER TIGHTEN THE HARDWARE!
NOTE: The SIDE KIX are directional so make certain the “BEDSLIDE” logo is facing forward and out!
DRIVER SIDE
LEFT/
PASSENGER SIDE
RIGHT/

Bedslide SIDE KIX Specifications

General

Category	Automobile Accessories
Model	SIDE KIX
Compatibility	Universal
Material	Aluminum
Mounting Location	Truck Bed
Mounting Type	Bolt-On
Weight Capacity	200 lbs

Summary

Attach Towers to Side KIX

Insert Mount Blocks into Guardrail

Remove Set Screw and Guardrail Bolt

Loosen and remove the set screw securing the plastic end cap and the bolt securing the guardrail.

Insert Mount Blocks

Insert two mount blocks into the open end of each guardrail.

Re-attach Guardrail and End Caps

Re-attach the guardrail to the side towers and secure the plastic end caps.

Attach Side KIX to Towers

Attach Support Bar