EasyManua.ls Logo

Bee-Ball ZYO24 - Before Installation

Default Icon
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
Before Installation
Check all parts are present!
Our factory takes every eort to make sure everything is packed in its proper place. But just in case a small part has gone
astray please make sure you check every piece is present before you begin installing - right down to the nuts and bolts.
Assemble with Care
Installation should be completed by two adults. Please make sure you follow all the instructions carefully. If you have
any questions during installation please do not hesitate to contact us on +441865 392439 or email
sales@biggamehunters.co.uk and we will be happy to advise.
Please make sure you read all the safety warnings and advice in this instruction manual. Take extra care and attention
over the wall xing instructions as this will make sure your equipment is rmly attached once you have completed the
assembly. Make sure you position the backboard somewhere with plenty of space to play.
Using the Basketball Equipment
Improper installation or use of the basketball backboard and ex ring may cause damage to the system or result in
serious injury to the user. We would advise that children are supervised at all times when using this product.
Please adhere to the warnings below to ensure proper use of this equipment and ultimately to ensure full enjoyment!
Attaching the Basketball Net
When attaching the net to your basketball hoop, make sure you have the net the correct
way up. The wider loops/wider part of the net should be at the top. Slide the loops of
the net over the metal loops on the inside of the basketball hoop - from the inside
towards the outside (see diagram 1). You can also see here a net that has been
assembled correctly and one that has been assembled upside down!
Assembling Your Backboard & Ring
diagram 1
Incorrect
Correct
1
Mark the Position of the Backboard
You will need:
Backplate (part 6)
Pencil
Decide where you would like your backboard to be xed and using the backboard frame as a template mark where
you will drill the holes in the wall. Alternatively you can skip this step and mark the position once the whole
backboard is assembled.

Related product manuals