INSTALLING YOUR BARBECUE
1200 SERIES BUILT-IN BBQ INSTRUCTIONS
To suit sizes: 3b, 4b and 5b
mm 3 burner 4 burner 5 burner
Width 675mm 825mm 994mm
Height (min) 230mm
Depth (including 20mm clearance at rear) 540mm
Clearance at rear (min) 75mm
Minimum clearance to combustion materials 450mm
General Requirements
We recommend that this installation be done in a masonry
structure and carried out by a professional tradesperson. Other
non-combustible material such as Hardiplank, Villaboard with
metal studs may also be used.
This appliance must not be installed under or on any combustible
material. Minimum clearance from combustible construction
materials to all sides of the appliance is
450mm (18”).
Warning: Contact your local municipality for any building codes
regulating the installation of outdoor barbecue appliances.
Outdoor installations must conform to local codes or, in the
absence of local codes, with:
• USA: National Fuel Gas Code, ANSI Z223.1/NFPA 54
• CAN: B149.1 Natural Gas & Propane Installation Code.
• AUST: Australian Standards Code AS: 5601
as well as the requirements of any local council, gas, electricity
authority or other statutory regulation.
26 INSTALLING YOUR BARBECUE
To Next Page
Loading...