Beef Eater 1200 Series

Questions and Answers

B
Brittany McbrideJul 29, 2025
Why won't my Beef Eater 1200 ignite?
- G
  gskinnerJul 29, 2025
  If your Beef Eater Grill fails to ignite, there are several potential causes. Make sure the gas cylinder valve is open by turning off the knob button and then opening the cylinder valve. Air might be mixed in the hoses; try to re-ignite and allow the grill to operate for a short while until it clears out. Check for a rubber hose that is wrapped, deformed, or pinched. Ensure the spark probe is in place, not deformed, and clean. If there is no spark, seek professional assistance.
R
robinsonchristinaAug 4, 2025
How to fix Beef Eater 1200 Grill flame going out?
- M
  Mrs. Courtney LeeAug 4, 2025
  If the flame on your Beef Eater Grill goes out while in use, it could be due to a few reasons. The gas cylinder might be empty, in which case you should replace it. There might be air mixed in the hoses; try to re-ignite the grill and allow it to operate for a short while until the air clears out. Another cause could be a blockage; in this case, seek professional assistance.
C
Carrie JohnsonAug 9, 2025
How to stop yellow tipping in Beef Eater 1200 Grill flame?
- G
  gonzalezfeliciaAug 9, 2025
  If you notice yellow tipping in the flame of your Beef Eater Grill, it could be due to an incorrect air/gas mixture screw in the burner. Try to open the screw to remove the yellow. If there is no change, seek professional assistance.
J
Joshua FergusonAug 15, 2025
What to do if my Beef Eater 1200 Grill smells like gas?
- E
  Elizabeth BartonAug 15, 2025
  If you notice a foul smell of gas coming from your Beef Eater Grill, there could be several reasons. First, the hose might be damaged; in this case, turn off the cylinder valve and replace the hose. Second, there might be a leakage; perform a leak test and tighten connections where necessary. If you cannot rectify the leakage, stop using the appliance and seek professional assistance. Another cause can be that the burner went off, in that case shut off valves, wait for 5 minutes and reignite.
C
Carla WestAug 22, 2025
What to do if Beef Eater 1200 Grill flame separates or burns with noise?
- J
  Justin JohnsonAug 22, 2025
  If the flame on your Beef Eater Grill appears to separate from the burner or burns with noise, it is likely due to a blockage of burner ports. Clean the burner thoroughly. If the problem persists, seek professional assistance.