Beef Eater 1200 Series - Side Burner Connection Safety; Gas Tightness and Leak Testing

To Next Page

To Previous Page

CONNECTING THE SIDE BURNER

Connect the other side of gas hose

(B) to the BBQ connection using 2

spanners.

WARNING

To ensure gas tight connections,

complete the gas leak test procedure

before and after gas hose connection

and after every reconnection of the gas

cylinder. Failure to do so may result in

a fire or explosion.

Leak test procedure

• Ensure all gas valves are in the ‘OFF’ position.

• In a small container, mix a solution of water and detergent

or soap.

• After connection of the hose, turn on the gas supply at the

gas bottle.

• Using a brush apply the solution to all gas connection

points and look for bubbles forming.

• Bubbling will indicate a leak.

• Turn off the gas supply and re-tighten the joint.

Repeat the leak test.

• If the leak persists, turn off the gas at the bottle and contact

a licensed gas fitter to correct.

CONNECTING THE SIDE BURNER