Beghelli SanificaAria 200 Connect - Page 14

8
DISPOSAL
The packaging is made out of recyclable materials. Dispose of it according to environmental protection
regulations, by separate collection.
According to European Directive 2012/19/EU, the device fallen into disuse must be disposed of in a compliant
manner: It must not be discarded as unselected municipal waste. It must be taken to recycling centres or
sent back to the Beghelli vendor.
Recyclable materials used in the appliance can be recovered to avoid environmental pollution.
For more information, please contact your local disposal authority or the appliance vendor.
INSTALLATION WITH FLOOR SUPPORT
- Connect the power cable to the mains
- Unscrew the screws and remove the circuit cover
- Carry out the wiring as indicated
- Replace the cartridges, the cover and close the device
- Remove the support bracket
- Open the door of the device
- Unscrew the 2 safety screws
- Slide the cover upwards to remove it from the catch, then pull it out
- Unscrew the safety screws and remove the cartridges
- Remove the aesthetic covers and the relative xing nuts (8mm wrench)
- Using the template supplied, make 4 holes in the wall (screws and wall plugs not supplied; Ø 6mm wall plugs
and Ø 4.5mm cross screws recommended)
- Pre-assemble the screws leaving them out of the wall by at least 5mm
- Hang the device through the slots on the bottom then tighten the screws
- Connect the power cable to the mains
- Replace the cartridges, the cover and close the device
LED SIGNALS:
- WHITE: DEVICE IN STANDBY, SANITIZATION OFF
- LIGHT BLUE: regular operation, SANITIZATION ON
- BLUE: regular operation with Bluetooth
®
(BLUE LED with sanitizer
connected to the SanicaAria App)
- RED: operating anomaly (check the type of anomaly with the SanicaAria App or
DOM-E):
- “uvOxy cartridge exhausted” (replace the cartridge)
- “blown fan” (the device must be repaired by the technical assistance service)
Note: The device contains two uvOxy cartridges. In case of exhaustion of
only one of the two cartridges, the sanitizer continues to operate with reduced performance, until the other
cartridge runs out. Replace both cartridges as soon as possible.
ON / OFF BUTTON:
On / off and manual adjustment of the fan speed.
- FIRST PRESS: Speed 1 (1 beep)
- SECOND PRESS: Speed 2 (2 beeps)
- THIRD PRESS: Speed 3 (3 beeps)
- FOURTH PRESS: STAND-BY (long beep)
N.B. The device turns on at speed 2.
After a power cut, the device ALWAYS turns on at minimum speed.
WALL INSTALLATION WITH CABLE POWER
WALL INSTALLATION WITH POWER SUPPLY FROM DUCT
OPERATION AND ADJUSTMENT
A
B
B1
C
ON/OFF + SPEED
LED