Bego LaserStar T Plus - Page 40

37
86076 DB-en/03 355.00032
English
⋅
LaserStar T Plus
en
Fig. 34 Editing the pulse shape
The pulse shape is determined by 8 nodes and
indicated in a time amplitude diagram (x-axis: time,
y-axis: amplitude).
The starting point ((A) in the figure above) and the
end point (B) cannot be changed.
The remaining nodes (example (C)) are marked by
circles and can be changed at the touchscreen.
Amplitude [ % ] / Time
The numerical values of the time and amplitude
coordinates of the nodes are displayed on the top
edge of the graphic editor.
A = 1.00
The relative pulse energy (= area of the pulse
shape) is indicated in the center of the diagram ((D)
in Fig. 34). The value 1.00 corresponds to the max.
energy (in Joule) of the rectangular pulse shown
above.
Shape 11
The current name of the pulse shape is indicated
below the pulse form graphic.
Change pulse shape
1. To move a node, touch the respective node,
drag it to the desired position and release it.
 Two concentrical red circles mark the cur-
rently activated node (see Fig. 35).
 The connecting lines to the neighboring
nodes follow the movement of your finger or
pointer on the touchscreen.
Fig. 35 Changing the pulse shape
Change pulse shape names
1. Touch the pulse shape name below the pulse
shape graphic.
 The → ALPHANUMERIC INPUT WINDOW
is opened with the prompt Please enter shape
name.
2. Enter the desired name (max. 16 characters)
and confirm with [ ↵ ].
 The alphanumeric input window is closed
and the new name is displayed in the pulse
shape editor.
NOTE
Restrictions when moving nodes.
• The two outer nodes can only be moved up
and down.
• The other nodes cannot be moved horizon-
tally beyond the neighboring nodes.
• The step interval is 5 %.