Bego LaserStar T Plus - Page 63

60
86076 DB-en/03 355.00032
English
⋅
LaserStar T Plus
en
Fig. 53 Allen screws/Rearside of the device
6. Remove the 2 Allen screws at the rear of the
device. The arrow in Fig. 53 shows the position
of the screw on the left side (seen from
behind).
7. Lift up the cover and put it upside down onto
the prepared space left of the device.
Refitting
1. Place the cover on top of the device and tigh-
ten it with the four Allen screws.
2. Remount the microscope (
→ MOUNTING THE
STEREO MICROSCOPE).
3. Adjust the microscope (
→ ADJUSTING THE
STEREO MICROSCOPE).