Behncke QWT - General Information and Safety Information; Product-Related Information

2
Heat exchanger QWT, WTI, SWT / General information and safety information
ENGLISH
2 General information and safety information
• All BEHNCKE products are made from high-quality materials.
This guarantees years of trouble-free operation.
• These properties will be retained for many years so long as the installation parts are handled
carefully and operated and maintained in accordance with our instruction manual.
• We recommend arranging a maintenance contract with your specialist swimming pool dealer.
Thisis an optimal prerequisite for safe operation, even beyond the warranty period.
• The cross-wound coil heat exchanger is designed for heating swimming pool water in private pools
in non-explosive spaces.
CAUTION
Watch out for edges and corners during unpacking and assembly.
Wear gloves.
• Assembly, installation and maintenance may only be carried out by trained and authorised
specialists.
• Only use specially suitable stainless steel tools when handling stainless steel.
• Within the agreed warranty period, no unauthorised procedures or modications may be carried
outunless done with the express consent of our company. Failure to comply with this will
invalidate the warranty.
• Please order replacement parts from your specialist swimming pool dealer.
• Only use the components / accessories supplied. If a component or accessory is missing,
you can request the missing original part from us.
The heat exchanger is designed for heating swimming pool water in private pools in non-explosive areas.
The heat exchanger in the QWT series is designed exclusively for heating up pool water by means of a hot
water heater.
The SWT series heat exchanger is designed exclusively for heating pool water using a heat pump,
solarpower system or a low-temperature heating system.
The WTI series heat exchanger is designed exclusively for heating pool water by means of a hot
waterheater; suitable for water with an increased chloride content (e.g. brine pools, therapy pools,
seawater pools).
The SWT-T series heat exchanger is designed exclusively for heating pool water using a heat pump,
solarpower system or a low temperature heating system; suitable for water with an increased chloride
content (e.g. brine pools, therapy pools, seawater pools).
Any other use or use that goes beyond this is considered improper use.
The manufacturer, Behncke GmbH, is not liable for any damage resulting from this.
Other uses are only possible following consultation with and approval from the manufacturer.
2.1 Product-related information