Behringer B-Control Deejay BCD3000 - Page 2

B-CONTROL DEEJAY BCD3000 QUICK-START GUIDE
Version 1.0
*not included
XM8500*
BCD3000
Turntable*
HPX4000*
Computer*
USB cable
Step-by-step installation
Now that you know the terminology and have all the gear you will need to
produce high-quality audio podcasts, it’s about time you set up the equipment,
install the software and get started.
1. Install the drivers provided on the BEHRINGER software CD when using
a computer with a Windows operating system (not required for Mac OS X
operating systems).
2. Connect your new BCD3000 controller interface to your computer with the
included USB cable.
3. Connect 2 turntables or a single turntable and an additional sound source
(for example, a CD player) to the respective RCA connectors of the BCD3000
interface. When a turntable is connected to the analog input, remember to
switch to Phono.
4. Connect a microphone to the XLR Microphone input of the
BCD3000interface.
5. Connect a pair of headphones to the console’s Headphone output.
Shouldyouwant to monitor the recording sessions with loudspeakers,
connect the Master output to your hi- system or a pair of active speakers.