BASS GRAPHIC EQUALIZER BEQ700
Thank you for showing your confidence in us by purchasing the BEHRINGER BASS
GRAPHIC EQUALIZER BEQ700. This ultimate effects pedal is specifically designed to
match the frequency range of bass guitars. It allows 7-band sound shaping and feedback
elimination from 50 Hz to 10 kHz. It has a powerful 15 dB boost/cut per band, ideally
suited even for 5-string and 6-string bass guitars.
1. CONTROLS
Top view
The 7-band EQ faders allow boosting/cutting single frequency ranges from 50 Hz
to 10 kHz at +/-15 dB.
The LEVEL fader adjusts the output level. It can be used to achieve effective
volume boost or cut.
This LED illuminates when the EQ is activated. It also serves as a battery level
indicator.
Use the footswitch to activate/deactivate the EQ.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery, press the hinges with a ballpen and remove the pedal cover. Be
careful not to scratch the unit.
+ The BEQ700 has no on/off switch. As soon as you insert the jack into the
IN connector, the BEQ700 begins running. When not using the BEQ700,
remove the jack from the IN connector. This extends the life of the
battery.
The SERIAL NUMBER is located at the bottom.
To Next Page
Need help?
General
