GRAPHIC EQUALIZER EQ700
Thank you for showing your confidence in us by purchasing the BEHRINGER GRAPHIC
EQUALIZER EQ700. This high-quality stompbox is specifically designed to provide complete
tone control and eliminate unwanted feedback. It allows 7-band sound shaping and feedback
elimination from 100 Hz to 6.4 kHz with a powerful 15 dB boost/cut per band.
1. CONTROLS
Top view
The 7-band EQ faders allow to boosting/cutting single frequency ranges from
100 Hz to 6.4 kHz at +/-15 dB.
The LEVEL fader adjusts the output level. It can be used to achieve effective
volume boost or cut.
This LED illuminates when the EQ is activated. It also serves as a battery level
indicator.
Use the footswitch to activate/deactivate the EQ.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery, press the hinges with a ballpen and remove the pedal cover. Be
careful not to scratch the unit.
+ The EQ700 has no on/off switch. As soon as you insert the jack into the IN
connector, the EQ700 begins running. When not using the EQ700, remove
the jack from the IN connector. This extends the life of the battery.
The SERIAL NUMBER is located at the bottom.
To Next Page
Need help?
General
