19
ULTRADRIVE PRO DCX2496
If you wish to store the current preset before loading a new one,
cancel RECALL and change to the STORE menu (see chapter
4.8).
The parameter RECALL NR allows you to select the BANK,
from which to load a preset (INT or CARD) and the NUMBER of
the preset. Both values are shown in the large right-hand window
Use the data wheel to select a preset (1 - 60). Confirm your
selection with OK to return to the previously selected menu (before
entering RECALL).
+ Empty presets (without a name) cannot be RECALLED.
4.8 STORE menu
Use this menu to store previously created presets in the internal
memory or on a PCMCIA card.
+ Only use 5 V ATA Flash Card PC cards. Though the
memory capacity of the storage medium can be selected
freely, it is impossible to store more than 60 presets. If
you need more memory capacity you can store your
presets externally on a PC (data dump via RS-232 or
LINK RS-485 interface).
4.8.1 INTERNAL/CARD
Fig. 4.46: Store ß Internal/Card
In this menu, STORE TO selects the bank to which the preset is
stored: INTERNAL or CARD. The window on the right-hand side
lists the presets already stored in the internal memory or on a
PCMCIA card. You can allocate a memory location to the preset,
give it a NAME and overwrite an existing configuration or select
an unused memory location. If you want to overwrite an existing
preset, then confirm your command with OK. The display will
prompt you to confirm once again. Press OK to confirm, or
CANCEL to quit.
Fig. 4.47: Store ß Internal/Card
If the preset to be overwritten was previously locked in the
PRESET LOCK menu (see chapter 4.8.4), the process cannot be
completed; a corresponding message is displayed.
Fig. 4.48: Store ß Internal/Card
If you save to an unused preset location, the store command
will be executed directly, i.e. without further prompts.
+ Please note that you have to assign a name to each
preset. Presets without a proper name cannot be saved.
AUTO-STORE
Your DCX2496 features an AUTO-STORE function. This
means that all settings are saved automatically, once every
few seconds, to a temporary, non-volatile memory. For
example, if there is a power failure while youre editing, at
least the last few edits (before the last auto-store operation)
are available directly from the auto-store memory. This
function cannot be disabled.
4.8.2 DELETE/FORMAT
Fig. 4.49: Store ß Delete/Format
On the next menu page you can erase presets from the internal
memory or an external memory card. Similar to the previous page,
just use DELETE to select the BANK (CARD or INT), then, in the
right-hand window, mark the preset to be deleted. When you press
OK, the display prompts you to confirm your selection.
Fig. 4.50: Store ß Delete/Format
Press OK to delete the preset. Locked presets cannot be deleted.
Fig. 4.51: Store ß Delete/Format
Additionally, this menu page allows you to format a memory
card. If CARD was selected in the DELETE menu, and the
FORMAT CARD function is enabled, the lower display line changes
from PUSH OK TO DELETE to PUSH OK TO FORMAT.
Fig. 4.52: Store ß Delete/Format
When you confirm with OK, the preset warns you that formatting
will erase all existing presets on the card.
4. MENU STRUCTURE AND EDITING
To Next Page
Loading...
