16 EUROPORT MPA100BT/MPA30BT Quick Start Guide 17
EUROPORT MPA100BT/MPA30BT Getting started
(EN) Step 3: Getting
started
Connect the MPA30BT/MPA100BT to
a power outlet by using the included
IEC power cable.
Turn all LEVEL knobs and the
MAIN LEVEL knob down to the
full counter-clockwise setting.
Connect all analog microphone,
instrument, and/or RCA cables to their
respective input jacks.
Power up the MPA30BT/MPA100BT by
pressing the POWER switch to the
“on” position.
If you are using BEHRINGER wireless
microphones, plug the wireless dongle
into the WIRELESS SYSTEM USB input.
The WIRELESS SYSTEM LEDs will light up when the
wireless microphones become active.
To pair a Bluetooth device with
the MPA40BT/MPA40BT-PRO,
follow these steps:
• Open Bluetooth in your mobile phone,
MP3 player or other Bluetooth equipment to
pair and connect.
• In your Bluetooth device, enter the PIN code: 0000
(Bluetooth version 2.0 and above will not require
a PIN code).
• If your Bluetooth device does not receive a
connection request, press and hold the Bluetooth
button until it ashes quickly, and then re-scan
for devices on your mobile phone or mp3 player.
While playing music from your Bluetooth
device, turn the BLUETOOTH/MP3 LEVEL
knob to about the 50% position.
Slowly rotate the MAIN LEVEL knob
clockwise until you achieve a
comfortable listening level.
While speaking into each microphone,
slowly rotate the INPUT LEVEL
knob clockwise until you nd a clean,
clear sound. If a microphone signal sounds distorted,
rotate the LEVEL knob slowly counter-clockwise until
the sound cleans up.
If you have an instrument plugged into
an INPUT channel, play the instrument
and slowly rotate that channel’s LEVEL
knob clockwise until you nd an acceptable level.
Balance all of the audio channels against
each other by adjusting each channel’s
respective LEVEL knob until you nd an
acceptable mix.
Make nal adjustments to the
MAIN LEVEL knob.
Guitar
To Next Page
Loading...
Need help?
General
Weight and Dimensions
