Behringer MicroMIX MX400 - Power Input and Signal Ports; Channel Level Adjustment Controls; Power Indicator and Serial Number Location

2
MICROMIX MX400
(1) Connect the power supply unit to your MX400 using the 12 V
connector. Connectingthe power supply unit to the mains
automatically switches the MX400 on. Todisconnect the unit
from the mains, pull out the main cord plug.
◊ ◊ When installing the product, ensure that the plug is
easily accessible. Ifmounting in a rack, ensure that the
mains can be easily disconnected by a plug or by an all-
pole disconnect switch on or near the rack.
(2) Up to four line signal sources can be connected to these
¼" TS connectors (INPUT).
◊ ◊ In case the volume level of one of the signal sources is
set too high, the input of the corresponding channel
may produce distortion!
(3) The OUTPUT carries the MIX signal and is on a ¼" TS connector.
(4) This ON LED is illuminated as soon as the unit is connected to
the power.
(5) Using the LEVEL controls you can set the output level of
eachchannel.
◊ ◊ High volume levels can damage your hearing or your
headphones. Pleaseturn down all volume controls
to zero (allthe way to the left) beforeyou power
up the amp. Always make sure you use appropriate
volumelevels.
SERIAL NUMBER. The serial number of the MX400 is located
at the bottom.