Need help?Do you have a question about the Behringer X-TOUCH ONE and is the answer not in the manual?
General| Transport Controls | Yes |
|---|---|
| Connectivity | USB |
| Channels | 1 |
| LCD Display | Yes |
| Faders | 1 x 100mm motorized fader |
| Rotary Encoders | 1 x Rotary Encoder |
| Footswitch | 1 x footswitch input |
| USB | USB 2.0 |
| Power Supply | USB bus-powered |
Guides the initial physical connection and setup of the X-TOUCH ONE.
Details the various buttons, encoders, and displays on the X-TOUCH ONE.
Explains how to change operational modes and adjust display settings.
Provides typical uses of X-TOUCH ONE controls in DAW applications.
Guides the user through the initial setup and operation of the X-TOUCH ONE.
Provides a general introduction to the X-TOUCH ONE's features and capabilities.
Explains the software setup requirements for the X-TOUCH ONE.
Details the necessary steps for connecting the X-TOUCH ONE hardware.
Describes the different communication protocols and modes supported by the X-TOUCH ONE.
Provides instructions on how to change the operating mode and adjust display settings.
Explains how to assign custom functions to buttons in MC User mode.
Guides the user on selecting the appropriate control surface in their DAW software.
Provides instructions for updating the X-TOUCH ONE firmware.
To Next Page