Behringer MOTOR 61 - Page 12

12 MOTÖR 61 / MOTÖR 49 User Manual
4.4 P.CHNG MENU
There are 2 options for this Program Change menu: PAD ASSIGN or SINGLE SEND
PAD ASSIGN
This menu assigns xed program change commands to the pads. The following
steps are available for each pad (in each PAD BANK):
1. Select PAD – press the PAD you would like to assign a program change
command to.
2. MIDI OUT – select from USB+MIDI, MIDI, or USB.
3. MIDI CHAN – select the MIDI channel on which the program change
command should be sent. Choose from 1 to 16, ALL, GLOBAL Channel,
or OFF.
4. Select TYPE – you can send a simple program change command (PGM CHNG)
or a program change in a specic sound bank (BANK+PGM CHNG).
5. Select MSB (if BANK+PGM CHNG had been selected in step 4).
6. Select LSB (if BANK+PGM CHNG had been selected in step 4).
7. Select NUMBER – (Program Change command 0-127).
8. Select FIX if a single specic sound should be sent out, INC or DEC if each pad
press should step upwards or downwards in the sound bank.
After a program change command has been assigned to a pad using these
options, it can be sent as follows: Press the P.CHNG button and press the pad
(or the appropriate BANK and then the pad), and the command will be sent.
You can also press other pads at this time. Press PRESET, GLOBAL, or EDIT buttons
to return the pad to its original operation.
SINGLE SEND
This allows you to set up a single program change message and send it instantly
to an attached DAW or synth. Follow these steps to set up a single send:
1. Select PGM CHNG, or BANK+PGM CHNG.
2. Select MIDI OUT port (USB+MIDI, MIDI, USB).
3. Select MIDI CHANNEL (1-16, ALL, GLOBAL CH, OFF).
4. Select MSB (if BANK+PGM CHNG had been selected in step 1).
5. Select LSB (if BANK+PGM CHNG had been selected in step 1).
6. Select NUMBER (Program Change command 0-127).
7. Press DATA knob to conrm, and press again to send this single program
change command.
8. Press P CHNG button to return to the main menu, where you can make
settings for an additional single program change to send out. Alternatively
press PRESET (or any other MAIN MENU button, apart from P. CHNG)
to return to the original pad operation.