Behringer Racktuner BTR2000 - Calibrating the Tuner

10
RACKTUNER BTR2000
Bass (BAS)
This mode is especially well suited for a 6-string bass. (B - E - A - D - G - C)
Baritone (brt)
This setup helps you tune a guitar to a baritone tuning, in which each string is tuned 5 half-tones (a
fourth) lower than a normal guitar. (B - E - A - D - F sharp - B)
Banjo (bjo)
The very widely used banjo tuning is made possible with this mode. (G - D - G - B - D)
Ukulele (ule)
The BTR2000 recognizes the notes of the open strings of a ukulele. (G - C - E - A)
Open D (o-d)
The open strings are tuned so that they create a D major chord. (D - A - D - F sharp - A - D)
Open E (o-E)
The open strings are tuned so that they create an E major chord. (E - G sharp - E - G sharp - B - E)
Open G (o-G)
All open strings create a G major chord. One good variant of this is the following tuning:
G - B - D - G - B - D. Since the low strings are under very high tension in this tuning, the strings can also
be tuned as follows: D - B - D - G - B - D
Open A (o-A)
The tuner recognizes only the notes of an A major chord. (E - A - C sharp - A - C sharp - E)
DADGAD (dad)
In this mode, the tuner recognizes the following notes: D - A - D - G - A - D.
+ When it is switched off, the BTR2000 stores the selected tuner mode.
The names of the notes are shown on the display as follows:
/&''LVSOD\ (QJOLVK1RWH1DPH
@
C
A?
C
#
/D
b
A
D
B?
D
#
/E
b
B
E
C
F
D?
F
#
/G
b
D
G
>?
G
#
/A
b
>
A
??
A
#
/B
b
?
B
Tab. 4.1: Note display
4.3 Calibrating the tuner
To give you every available option for tuning your instrument, you can change the setting of the
standard A pitch. In order to clarify what this involves we will take a slight digression.
The so-called standard A pitch has risen over time since its initial measurement: The tuning forks
used by Bach, Händel or Mozart were at 415, 420 or 421 Hz (cycles per second). Todays orchestras
tune to an A of 444 Hz. The Berlin Philharmonic is right at the forefront: their standard A is 447 Hz.
The pitch of the standard A on the BTR2000 is set at the factory to 440 Hz. In the event you want to
play with a major orchestra that tunes to a standard A of 444 Hz, you need a function that will let you
change the frequency of the A.
+ The calibration settings are stored even if you switch the BTR2000 off.
4. TUNER