Behringer Ultra-G - Bass Guitar or Keyboard Signal Pickup

7
ULTRA-G GI100
The second example shows the GI100 being driven by the loudspeaker output
of a guitar amp. If youre using a tube amp, its very important to connect an
impedance loadpreferably a speakerto the DIRECT LINK TO CABINET
output in order to prevent damage to your amp. For this application, start with
one PAD switch depressed and the GND LIFT switch activated. We also
recommend using the VIRTUAL CAB speaker simulation for an authentic guitar
sound.
2.2 Picking up a bass guitar or keyboard signal
Fig. 2.2: 1. Bass guitar ß GI100 ß Amplifier/Console
2. Keyboard ß GI100 ß Amplifier/Console
2. CONNECTION EXAMPLES
DATA-MANFULL_GI100_ENG_Rev A.p65 07.09.01, 15:437