9
ULTRA-G GI100
Fig. 2.3: Connection to an amplifiers output
+ Before connection to a loudspeaker output, always make sure that
the GND LIFT switch is activated (depressed) to prevent accidental
short-circuiting of the amplifier output. The metal casing of the
GI100 should not have direct contact with other equipment. The
tip of the output socket should be connected to the positive (red)
loudspeaker pole.
3. SPECIFICATIONS
Frequency response 10 Hz to 160 kHz
Noise -99.2 dBu
Distortion < 0.014% (1 kHz, 0 dBu in)
Input resistance > 250 kOhm
Connection impedance > 600 Ohm
Input 1/4" mono jack
Output XLR balanced
Max. input level +8/+28/+48 dBu (Simulation OFF)
-2/+18/+38 dBu (Simulation ON)
Supply:
Phantom supply 18 V DC to 48 V DC
Battery 9 V 6LR91
Dimensions 6" (150 mm) x 5" (130 mm) x 2.4" (60 mm)
Weight approx. 650 g
BEHRINGER is constantly striving to maintain the highest professional standards. As a result of
these efforts, modifications may be made from time to time to existing products without prior notice.
Specifications and appearance may therefore differ from those listed or shown.
3. SPECIFICATIONS
DATA-MANFULL_GI100_ENG_Rev A.p65 07.09.01, 15:439
To Next Page
Loading...
