Behringer ULTRA VIBRATO UV300 User Manual

ULTRA VIBRATO UV300
Classic Vibrato Eects Pedal
Thank you for showing your condence in us by purchasing the BEHRINGER ULTRA VIBRATO UV300.
This high-quality eects pedal delivers the classic pitch modulation and dimensional vibrato eects
of the ‘60s and ‘70s. Its comprehensive controls allow you to tailor the UV300 performance right for
your needs.
1. Controls
(1) The MODE switch changes the functionality of the eects pedal footswitch. When set to LATCH,
the eect will be activated/deactivated by pressing the pedal once. When set to UNLATCH,
the eect will only be active if you depress the pedal. The BYPASS mode can be selected when
no vibrato eect is required. The input signal remains uneected even if the pedal is depressed.
(2) The RISE control adjusts the time needed for the eect to reach its maximum detuning.
Modulation sets in more slowly when it is turned clockwise.
(3) The RATE control determines the speed of the vibrato eect.
(4) The DEPTH control adjusts the intensity of the pitch modulation eect.
(5) The ON/BATT LED illuminates when the eect is activated. It also serves as a battery level indicator.
(6) Use the footswitch to activate/deactivate the eect.
(7) Use this ¼" TS IN connector to plug in the instrument cable.
(8) The ¼" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery
(not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful not to
scratch the unit.
(1)
(8)
(5)
(4)
(7)
(6)
(2) (3)

Behringer ULTRA VIBRATO UV300 Specifications

Power

power supply	9 V, 100 mA regulated
power consumption	30 mA
battery type	9 V type 6LR61

Ports & Interfaces

input connector	1/4" TS
input impedance	500 kΩ
output connector	1/4" TS

Weight and Dimensions

dimensions	54 mm x 70 mm x 123 mm
weight	0.33 kg