8
V-TONE GMX110/GMX210/GMX212/GMX1200H
4. EFFECTS PROCESSOR
3.4 Wiring the GMX1200H
The GMX1200H head features two LOUDSPEAKER outputs
(EXT LEFT and EXT RIGHT) that can be used to connect one or
two external loudspeakers. To get the most power from the
GMX1200H, both loudspeaker outputs should be used and
connected to speakers with minimum 8 Ohms impedance.
Loudspeaker outputs are automatically muted as soon as you
activate the tuner or connect a set of headphones (see
section 5.1). To assure optimal and safe use of your amplifier,
please also read section 6.2.
When the GMX1200H is used with a single BEHRINGER
ULTRASTACK BG412V, the rear panel switch of the BG412V
must be in the stereo position and the two outputs should be
connected as shown in fig. 3.4.
When using two speaker cabinets to form a classic full-stack
please make sure the impedance of each speaker cabinet is
between 8 to 16 Ohms (see fig. 3.5).
Fig. 3.4: GMX1200H with an ULTRASTACK BG412V
in stereo mode
Fig. 3.5: GMX1200H with two speaker cabinets
4. EFFECTS PROCESSOR
Effects are the icing on the cake when it comes to creative
sound designs. On the one hand, direct recordings (i.e. recordings
without a microphone, which is possible with the V-TONE) are
all about placing the guitar sound in an artificially created space
since no natural ambience is possible. On the other, effects
such as delay, chorus, flanger and tremolo are an integral part
of the modern guitar sound. For this reason, weve equipped the
V-TONE with an effects processor that lets you create a
professional-grade sound that you are used to hearing on your
favorite recordings. This way, you are one giant step closer to
emulating your fave sounds without having to schlep a rackfull
of effects everywhere you go.
The integrated multi-effects processor offers the same audio
quality found in our 19" effects unit VIRTUALIZER PRO, known
for being used in studios. You get 31 different groups of first-
class effects at your disposal, for example reverb, chorus,
flanger, delay, pitch shifter, compressor, expander, Wah
variations, various combination effects and even tube and
speaker simulations. All in all, there are 99 presets you can use,
offering you a wide variety of different-sounding effects. You
can edit one parameter on each preset directly on the V-TONE
and three parameters via MIDI. Additionally, the multi-effects
processor lets you mix and match different effects with different
speakers, depending on each preset. Presets can be overwritten
with your own creations.
To Next Page
Loading...
