Access Point
This mode only supports DHCP Server operation with a maximum of 4 clients, working on Wifi channels 1-11. Security
is supported via WEP 40-bit (5 ASCII characters) or WEP 104-bit (13 ASCII characters). By default, the mixer will use a
network name consisting of the model name plus the last bits of the mixer’s unique MAC address (e.g. XR16-17-BE-
C0). The default IP address is 192.168.1.1 and no security is engaged. The control software is available for Android
and iPad tablets as well as PC/ Mac/Linux computers. Visit behringer. com to download the PC/Mac/Linux software.
The tablet software can be downloaded from the app store on your device. To learn more about operating the control
software, visit the product page on behringer.com to download the full manual.
Getting Started
First Wifi remote connection to your X AIR mixer
1. Download and install the remote control app for your device.
Android smartphones/tablets: X AIR Android from the Google Play* store
iPad: X AIR for iPad from the App Store
PC: X AIR EDIT for Windows*, Mac or Linux from behringer.com
2. Set the REMOTE switch on your X AIR mixer to ACCESS POINT mode and power on the mixer.
3. Reset your X AIR mixer’s network settings to default values by holding the RESET button for 2 seconds. This is
located in the small hole above the Wifi icon and requires a paper clip or similar tool to reach.
4. Switch your remote control device on and open the network settings.
Android smartphones/tablets:
1. Start the Settings/Wireless & Networks dialog on your Android system.
2. Switch `Wifi’ on.
3. Click on `Wifi’ to select a network. From the list of networks, select your X AIR mixer’s name, e.g. “XR16-19-1B-
07”. After a few seconds, the status should change to `Connected’.
4. Open your X AIR for Android app and it will show similar information:
To Next Page
Loading...
