Wifi Client
This mode supports DHCP Client (default) and fixed IP operation. The XR16/XR12 can support WEP, WPA and WPA2
security mechanisms in Wifi Client mode and works on Wifi channels 1-11.
Correct SSID (network name) and password need to be supplied to connect to an existing network. WEP passwords
have to be either 5 characters or 13 characters long. If the supplied SSID and password are incorrect, the mixer cannot
be accessed. In this case the networking parameters have to be reset and another connection mode has to be used to
regain access. The Ethernet connection mode may be used for configuration of the Wifi Client mode. While being
connected in Ethernet mode, the X AIR mixer can scan the available wireless networks and display their SSID network
names, field strength and security method. By selecting the preferred wireless network, this information can be copied
to the applications’ Wifi Client setup page automatically. You will then be prompted to fill in the security password of that
network. After switching from Ethernet to Wifi Client mode, the mixer should connect to the selected wireless network
automatically, and will be displayed by remote applications on any device connected to the same network.
Access Point setup screen
To Next Page
Loading...
