Beijer Electronics X2 Pro/Extreme Web - Image Update; Update Panel Image via USB; Update Bootloader via USB

Image Update
5 ImageUpdate
The operator panel comes pre-loaded on delivery with a image.
5.1 UpdatingthePanelImageusingUSB
To update the image in an operator panel use a USB flash drive. This makes it
possible to upgrade the panel image without the use of a PC.
5.1.1 Imageupdate
Itispossibletoupgradethepanelimageonanoperatorpanel.
1. Download the system-beijer.raucb file and store it in the root on a USB
memory.
2. Attac h the USB memor y s tick to the device and turn on the power.
3. After booting up, a dialog will show to install the new version. A dialog will
notify when the update is finished.
4. Detac h the USB memory stick and reboot the device.
5. Check the new version number in the Configuration.
5.1.2 Bootloaderupdate
1. Download the bootloader-beijer.raucb file and store it in the root on a USB
memory stick.
2. Attac h the USB memor y s tick to the device and turn on the power.
3. After booting up, a dialog will show to install the new version. A dialog will
notify when the update is finished.
4. Detac h the USB memory stick and reboot the device.
5. Check the new version number in the Configuration.
BeijerElectronics, MAEN341
12