5 Special prompt
In normal condition, it could not memory present testing value while not reaching impact times
which has been set. If want to memory, press 【Cal. Average】 at the main display interface to end the testing
in advance and then memory；
When using the function of 【Cal. Average】 to end the testing in advance, the function of 【Auto
Save】、【 Auto Trans.】etc. will not work；
Not all hardness methods can be converted to each other for all materials（See table 1）. The setting of
hardness scale will recover to HL automatically after material setting is changed. So select 【Material】first then
select 【Hardness Scale】 when setting measure condition.
6 Operation explain in details
6.1 Switch on
Press to switch on，the screen will show as follows in 2 seconds:
TIME
○
R
5100
TIME Group Inc.
To Next Page
Loading...