6.15 Connection of data transmission cable
Insert one connection 4-pin plug of transmission cable into the USB socket on the side of the main unit,
and insert the other plug into the USB socket in the back of computer box. The computer will display
“TIME
○
R
510X Hardness Tester” founded.
After installation of driver program shipped with the tester, the driver program will imitate the hardness
tester as equipment used in COM3 or COM4.The driver program can be found and its characteristics such
as baud rate can be modified in “Equipment Manager” in computer. It can be displayed using “Super
terminal” etc.
TIME software for PC has includes the driver program.
7 Maintenance and repair
7.1 Impact device
● After the impact device is used for 1000--2000 times, use the cleaning brush provided to clean the
guide tube and the impact body. To clean the guide tube, unscrew the support ring firstly, then take
out the impact body, spin the cleaning brush in counter-clock direction into the bottom of guide tube
and take it out for 5 times, and then install the impact body and support ring again.
● Release the impact body after use.
● Any lubricant is absolutely prohibited inside the impact device.
To Next Page
Loading...