BEKA Grizzly User Manual

Beka, Inc. • 542 Selby Ave • St. Paul, MN 55102 • USA
1-888-999-2352 • www.Bekainc.com
ADJUSTABLE TAPESTRY LOOM
- The Grizzly -
Parts:
- 4 Side Uprights (38” long pcs)
- 2 Beams (pieces with plasc teeth)
- 2 Feet
- 6 Posioning Blocks (5” long pcs)
- 2 Assembly Hardware Packs:
• 8 - 1-1/2” wood screws
• 16 sets of bolts, washers & wing nuts
- 2 Pickup Scks
- 2 Shules
Assembly Instrucons:
Step 1
Step 2
Step 1)
Use wood screws to aach a Posioning Block to
the end of each Beam.
Step 2)
Use bolts to connect uprights in pairs;
connect uprights so the two sets are the same
length. Secure with washers and wing nuts.
Step 3)
Lay uprights on a table or oor and aach
beams; use bolts to connect posioning blocks to
uprights. Orient beams so teeth are close to the
center of the loom; teeth are on the lower edge
of the top beam and the top edge of the boom
beam.
Step 3

BEKA Grizzly Specifications

General

Brand	BEKA
Model	Grizzly
Category	Power Tools
Language	English

Summary

Assembly Instructions

Step 1: Attach Positioning Block to Beam

Use wood screws to attach a Positioning Block to the end of each Beam.

Step 2: Connect Uprights in Pairs

Use bolts to connect uprights in pairs, securing with washers and wing nuts.

Step 3: Attach Beams to Uprights

Attach beams to uprights, ensuring teeth are oriented correctly on top and bottom beams.

Step 4: Position and Attach Lower Beam

Attach each beam at the chosen level, using extra blocks as spacers if needed.

Step 5: Attach Feet to Uprights

Attach feet securely to the bottom of each set of uprights with washers and wing nuts.