What does it mean if the DMC15 yellow LED is flashing (LC 12-35) on my Beko Chiller?
If the DMC15 yellow LED is flashing (LC 12-35), verify the electric wiring of T2 fan control probe. The T2 fan control probe may be faulty, so replace it.
What does it mean if my Beko Bekoblizz LC 12-355 Chiller indicates service warnings with message PF – Failure temperature probe T1 (dew point)?
If the service warnings are indicated by the following messages: PF – Failure temperature probe T1 (dew point), check the electric cabling and/or replace the probe.
What to do if the LPS low-pressure switch was triggered on my Beko Bekoblizz LC 12-355 Chiller?
The pressure switch is automatically reset as soon as the normal conditions are re-established. Check the chiller for proper functioning.
Illustrations of safety symbols according to DIN 4844 for hazard communication.
Requirements for the installation environment, including ambient conditions and clearance.
Guidelines for connecting the chiller to the compressed air system, including safety and air quality.
Requirements for connecting the chiller to a water cooling system, including water quality.
Instructions for safe electrical connection, including voltage, earthing, and protection.
Instructions for connecting and managing the condensate drain system.
Step-by-step guide for the first start-up, including checks and operational sequences.
Detailed technical specifications for the LC 12-35 model, including airflow and power.
Technical specifications for LC 55-355 models with 1/230/50 power supply.
Technical specifications for LC 12-150 models with 1/115/60 power supply.
Technical specifications for LC 55-355 models with 1/230/60 power supply.
Control unit for LC 12-35 chillers, displaying dew point and controlling fan activation.
Identification of common faults, possible reasons, and suggested corrective measures.
To Next Page
General