Why Beko DFN05W13S Dishwasher does not start?
Your Beko Dishwasher might not be starting due to several reasons. It could be that the power cable is unplugged, so check if it's properly connected. A blown fuse in your house could also be the culprit, so inspect your fuses. Ensure that the water inlet tap is open and that the dishwasher door is fully closed. Finally, make sure you've pressed the On/Off button to turn the machine on.
Why Beko DFN05W13S leaves dishes not washed clean?
If your Beko dishwasher isn't cleaning dishes properly, several factors could be at play. Ensure dishes are loaded correctly as described in the manual. The selected program might be unsuitable, so try a program with a higher temperature and cycle time. Check that the impellers rotate freely and that their holes aren't clogged. Also, make sure the filter system is clean and correctly installed. Avoid overloading the baskets. Ensure your detergent is stored properly, and you're using a sufficient amount. Check the rinse aid level and adjust if necessary. Finally, verify the detergent dispenser lid is tightly closed.
What to do if Beko DFN05W13S leaves detergent in detergent dispenser?
If detergent remains in the dispenser of your Beko dishwasher, first ensure the dispenser was dry when you added the detergent. Add detergent shortly before starting the wash cycle. Make sure dishes aren't blocking the dispenser lid from opening or water from the impellers from entering. Avoid storing powder detergent in humid conditions. Check the impeller holes for clogs.
What to do if Beko DFN05W13S Dishwasher leaves lime traces on dishes?
If you notice lime traces on your dishes or a misty appearance on glassware after using your Beko dishwasher, it could be due to insufficient rinse aid. Check the rinse aid indicator and add more if needed, or increase the rinse aid setting. Also, ensure your water hardness setting is appropriate and the salt level is sufficient. Be careful not to spill salt when filling, and make sure the salt reservoir lid is tightly closed.
What to do if Beko DFN05W13S Dishwasher leaves water at the end of the programme?
If water remains in your Beko dishwasher after the program finishes, the filters might be clogged, so you should check and clean the filter system. Also, the discharge hose could be clogged or blocked. Inspect the hose, remove it if necessary, clear any blockages, and reinsert it.
Why Beko Dishwasher leaves tea stains on dishes?
If tea, coffee, or lipstick stains persist on dishes after a Beko dishwasher cycle, the selected program might be unsuitable. Try a program with a higher temperature and longer cycle time. The surface quality of your kitchen utensils may also be a factor, as stains can penetrate deteriorated surfaces. Avoid washing such utensils in the dishwasher. Improper detergent storage can also contribute, so avoid storing powder detergent in humid places and consider using tablet detergents.
Why Beko DFN05W13S has a different odour?
A strange odor in your Beko dishwasher could be due to clogged filters. Ensure you check and clean the filter system regularly. Alternatively, if you leave dirty dishes in the dishwasher for a few days, remove remnants and run the prewash program without detergent every two days. To prevent odors, don't fully close the dishwasher door when not in use. You might also consider using commercial odor removers or machine cleaners.
Why Beko DFN05W13S causes rust on dishes?
Rust, discoloration, or surface deterioration on dishes in your Beko dishwasher can occur for several reasons. Salt leakage can cause deterioration and oxidation, so be careful when filling the salt reservoir and ensure the lid is tightly closed. Run a prewash cycle to remove spilled salt. Salty food remnants left on dishes for too long can also contribute; prewash or wash dishes immediately. Check that your electrical installation is properly grounded. Avoid using intensive cleansers like bleach. Do not use metal items for unintended purposes. Low-quality stainless steel cutlery and already corroded items should not be washed in the dishwasher.
Why Beko Dishwasher breaks kitchen utensils?
Kitchen utensils may break in your Beko dishwasher if dishes are not placed orderly in the machine. Load the dishes as described in the user manual. Also, do not overload the baskets in excess of their capacity.
General| Type | Freestanding |
|---|---|
| Product Colour | White |
| Control Type | Electronic |
| Number of Place Settings | 13 |
| Noise Level | 49 dB |
| Number of Washing Programs | 5 |
| Energy Efficiency Class | E |
| Dimensions (H x W x D) | 85 x 60 x 60 cm |
| Width | 60 cm |
| Depth | 60 cm |
| Height | 85 cm |
| Delay Start | Yes |
| Half Load Option | Yes |
| Programs | Eco, Intensive, Quick, Prewash |
To Next Page
