How to fix a Beko DFS26020W Dishwasher that does not start?
If your Beko dishwasher isn't starting, first ensure the power cable is properly plugged in. Then, check the fuses in your house to see if any have blown. Also, verify that the water inlet tap is open and that the dishwasher door is fully closed. Finally, make sure you've pressed the On/Off button to turn the machine on.
Why are dishes not washed clean in my Beko Dishwasher?
If your Beko dishwasher leaves dishes unclean, ensure they are loaded properly as described in the user manual. Select a program with a higher temperature and cycle time. Before starting, manually rotate the lower and upper impellers to ensure they move freely. Regularly clean the impellers and filter system, and make sure the filters are correctly installed. Avoid overloading the baskets. If using powder detergent, store it in a closed container in a non-humid place, or switch to tablet detergents. Adjust the detergent amount to match how dirty your dishes are, and check/adjust the rinse aid level. Ensure the detergent dispenser lid is tightly closed after adding detergent.
What to do if water remains in Beko DFS26020W Dishwasher after cycle?
If your Beko dishwasher has water remaining after the cycle, check if the filter system is clean. Clean the filter system regularly. Also, inspect the discharge hose for any clogs or blockages. If necessary, remove the discharge hose, clear any blockages, and reinsert it.
Why does my Beko Dishwasher leave smear on glasses?
If your Beko dishwasher leaves a milky smear on glasses that you can't wipe off, and they have a bluish or rainbow tint, it could be due to excessive rinse aid. Try lowering the rinse aid setting and clean up any spilled rinse aid. Alternatively, soft water might be corroding the glass. Check the water hardness setting and consider not using salt if your water is very soft. You might also select programs with higher washing temperatures or use glass protective detergents.
How to dry dishes better in Beko DFS26020W?
To avoid having your Beko dishwasher leaving dishes wet after the cycle, place your dishes in a way that no water will accumulate in them.
Why does rust appear on dishes in my Beko DFS26020W?
If your Beko dishwasher has rust, discoloration, or surface deterioration on the dishes, make sure you don't spill salt when filling and that the salt reservoir lid is tightly closed. Run a prewash to remove any spilled salt. Also, remove salty food remnants with a prewash if you are not washing right away. Ensure your electrical installation is properly grounded to prevent static electricity. Avoid using intensive cleansers like bleach. Don't use metal items for unintended purposes. Low-quality stainless steel cutlery and already corroded items should not be washed in the dishwasher.
How to remove lime traces from dishes in Beko DFS26020W Dishwasher?
If your Beko dishwasher leaves lime traces or gives glassware a misty look, ensure the rinse aid level is sufficient. Check the rinse aid indicator and add rinse aid if needed, or increase the rinse aid setting. Also, measure the hardness of your water supply and adjust the water hardness setting accordingly. Be careful not to spill salt when filling the salt reservoir, and ensure the lid is tightly closed. Run a prewash cycle to remove any spilled salt, and check the lid again after the prewash.
Why is there an odor in my Beko DFS26020W Dishwasher?
If your Beko dishwasher has a bad odor, check and clean the filter system regularly. If you're not running the dishwasher immediately after loading, remove food remnants and run the prewash program every two days. Leave the door slightly open to prevent odor build-up. You can also use commercial odor removers or machine cleaners.
Why is there foam in my Beko Dishwasher?
If your Beko dishwasher has foam forming inside, it's likely due to hand-wash detergent residue. Avoid washing dishes with hand-wash detergent before loading them into the dishwasher. Removing coarse soil under tap water or with a paper towel is sufficient. Also, be careful not to spill rinse aid when filling and ensure the lid of the rinse aid reservoir is closed. Clean any spills with a paper towel.
Why does detergent remain in the Beko Dishwasher dispenser?
If your Beko dishwasher leaves detergent in the dispenser, make sure the dispenser is dry before adding detergent and add detergent shortly before starting the wash. Ensure dishes don't block the dispenser lid from opening or water from the impellers from entering. Store powder detergent in a closed container in a non-humid place, or use tablet detergents. Clean the impeller holes regularly.
General| Brand | Beko |
|---|---|
| Model | DFS26020W |
| Category | Dishwasher |
| Language | English |
General safety instructions to protect from personal injury or property damage.
Defines the product's intended use for domestic dishwashing only.
Provides a diagram and labels for the main components of the dishwasher.
Lists technical specifications and explains the fan drying system for efficient dish drying.
Guidance on selecting a suitable location for installing the dishwasher.
Instructions on connecting the dishwasher to the water supply and drain.
Instructions for adjusting feet, permitted water temperature, and electrical hookup.
Covers leak protection, initial operation, and electrical safety precautions.
Advice on energy efficiency and the importance of the water softening system.
Steps to adjust the water hardness level for optimal washing performance.
Instructions on how to add special dishwasher salt and detergent.
Explanation of rinse aid, dish loading guidelines, and basket features.
Explanation of the control panel, buttons, and key functions.
Steps to prepare the dishwasher and select the right wash programme.
Details on optional functions, special features, and time delay settings.
Managing Time Delay, starting/cancelling programmes, and indicator lights.
How to adjust rinse aid, steps at programme end, and error warnings.
Details on the InnerClean programme for machine cleaning and hygiene.
Instructions on how to clean dishwasher filters and the water inlet hose filter.
Instructions on how to clean the lower and upper impellers for efficient operation.
Solutions for common problems like machine not starting or dishes not clean.
Solutions for drying issues, stains, lime scale, rust, and foam.
Troubleshooting dispenser issues, broken utensils, and water remaining.
To Next Page
